Techni-Level Transducer Probes

These specially-designed Techni-Level Transducer Probes with 4-20 mA output are for refrigerant level control in computer operated industrial and commercial plants.

All transducer electronics are compact, sealed watertight, and located on top of the probe. A 24 Volt DC power input is required. Fifty feet of two-wire cable is included with longer lengths available. An optional 0-100% built-in digital readout is available. Probe active lengths up to 168" (4267 mm). Level columns are available from Hansen or can be field-fabricated.

For use with ammonia, R22, R134a and other compatible refrigerants.Techni-Level Transducer Probes are an ideal solution for computer-controlled applications on vertical or horizontal vessels, pump accumulators, pilot receivers, and refrigerant loss monitoring.

Designed to be inserted directly into refrigerant receivers and facilitate the continuous measurement of refrigerant liquid levels.

The following results can be tracked: refrigerant loss detection, refrigerant inventory measurements, warnings of excessive refrigerant levels, and insufficient refrigerant quantity. Factory pre-calibrated and tested with no moving parts to break, jam, or fail.

Horizontal Receiver Probes (SHP) can also be used in short [less than 30? (762 mm) insertion] vertical receivers. For vertical receivers 12? to 20? (305 to 508 mm) diameter (other diameters need special engineering). Maximum insertion length is 69? (1752 mm). Output signal 0-5V or 1-6V; 4-20 mA available, .